Enter the options menu to set optional DPM models.
Skip the pressure dependent boiling point calculation to allow supercritical pressure conditions for vaporization.
Enable/disable Brownian motion of particles.
Enable/disable convection/conduction film to wall heat transfer model.
Write the current positions (step-by-step history report for unsteady tracking) in the sampling file format.
Enable contour and vector plots of particle data.
Set ensemble average cloud properties.
Include LWF particle mass in DPM Concentration.
Initialize erosion/accretion rates with Zero.
Set the lowest volatiles mass fraction.
Maximum number of species that can interact with particles in the DPM UDFs.
Enable/disable particle radiation.
Enable/disable pressure gradient force.
Remove the wall film temperature limiter.
Enable/disable Saffman lift force.
Options to activate and configure the SCR urea deposition risk analysis.
Set the minimum particle diameter.
Set the thermolysis limit.
Provide a stagger radius for non atomizer injections.
Spatially stagger atomizer injections?.
Spatially stagger non-atomizer injections?.
Stagger transient parcels for their first time step?.
Set the staggering factor between 0 and 1 to control the amount of staggering.
Set significant figures in the step-by-step report.
Enable/disable thermophoretic force.
Enable/disable tracking in absolute frame.
Dump multicomponent particle mass if the saturation temperature cannot be determined.
Enable/disable calculation of DPM sources in TKE equation.
A uniform mass distribution will be enabled for all solid cone and atomizer injections.
Enable/disable using Absolute Pressure for Vaporization.
Enable/disable correction for Vaporization heat transfer.
Set Vaporization options.
Enable/disable virtual mass force.