Enters the prism smoothing controls menu.
Enables you to check the skewness of the prism cap for every layer.
When enabled, the offset height at corners with large angles (for example, 270º) is reduced to give a smoother prism cap.
Specifies the maximum allowable angle between the normals of the base faces for skewness-driven edge swapping.
Specifies the maximum allowable angle between the normals of the cap faces for skewness-driven edge swapping.
Min. skewness to smooth cap faces.
Enables or disables improving of face warp during prism generation. This option is disabled by default.
Controls checking for left-handedness of faces. The default setting of 0 implies face handedness will not be checked. A value of 1 implies only cap faces will be checked, while 2 implies faces of all cells in current layer will be checked.
Specifies the maximum skewness allowed for a prism cap face. If the skewness of a cap face exceeds this value, the meshing process will stop and a warning indicates that the skewness for that layer is too high.
Specifies the cell quality criteria for smoothing and quality checking.
Enables you to set the parameters for improving the prism cells after the required prism layers are created. You can select optimized smoothing (smooth), node movement (improve), or a combination of both to improve the quality. Specify the quality measure to be used, the cell quality threshold, the number of improvement iterations, and the minimum improvement required.