Enter the numerics menu to set numerical solution parameters.
Enable/disable the adaptation of integration step length based on a maximum error.
Average DDPM specific variables like volume fractions and velocities on nodes.
Do the averaging after each integration step for higher accuracy at a higher cost.
Specify a kernel for the averaging.
Average DPM source terms on nodes.
Enable/disable coupled heat and mass update.
Set the drag law.
Enable node based averaging of DPM variables.
Enable enhanced packing limit numerics to avoid exceeding of packing limit for granular phases.
Set the adapt integration step length based on a maximum error.
Set a factor for the gaussian kernel for node-based averaging.~%Large values give small size, small values give large size of kernel.
Evaporate droplet completely when the remaining mass is below this fraction of initial mass.
Enable PIC and MPPIC to compute DPM and DDPM source terms.
Set parameters for the (initial) tracking step length.
Specify a tracking scheme.
Control the format of the one-line tracking statistics printed after every DPM tracking pass.
Define underrelaxation factor for film height.
Set Vaporization Fractional Change Limits.
Adjust the DPM tracker’s verbosity level.